|
A torque tube system is a driveshaft technology, often used in automobiles with a front engine and rear drive. It is not as widespread as the Hotchkiss drive, but is still occasionally used to this day. Driveshafts are sometimes also used for other vehicles and machinery. == Construction == The "torque" that is referred to in the name is not that of the driveshaft, along the axis of the car, but that applied by the wheels. The design problem that the torque tube solves is how to get the traction forces generated by the wheels to the car frame. The "torque tube" transmits this force by directly coupling the axle differential to the transmission and therefore propels the car forward by pushing on the engine/transmission and then through the engine mounts to the car frame . In contrast, the Hotchkiss drive has the traction forces transmitted to the car frame by using other suspension components such as leaf springs or trailing arms. A ball and socket type of joint called a "torque ball" is used at one end of the torque tube to allow relative motion between the axle and transmission due to suspension travel. Later AMC/Rambler models (1962 through 1966) used a flange and cushion mount in place of the ball and socket.〔1962-1966 AMC Technical Service Manuals〕 Since the torque tube does not constrain the axle in the lateral (side-to-side) direction a panhard rod is often used for this purpose. The combination of the panhard rod and the torque tube allows the easy implementation of soft coil springs in the rear to give good ride quality . In addition to transmitting the traction forces, the torque tube is hollow and contains the rotating driveshaft. Inside the hollow torque ball is the universal joint of the driveshaft that allows relative motion between the two ends of the driveshaft. In most applications the drive shaft uses a single universal joint which has the disadvantage that it causes speed fluctuations in the driveshaft when the shaft is not straight. The Hotchkiss drive uses two universal joints which has the effect of canceling the speed fluctuations and gives a constant speed even when the shaft is no longer straight . The 1963-66 AMC Rambler big cars use a double-Cardan constant velocity joint in V8 powered models to eliminate driveshaft fluctuations, though six cylinder and earlier V8 models used only one standard universal joint.〔1963-1966 AMC Technical Service Manuals〕 The torque tube design is typically heavier and securely ties the rear end together, thus providing for a rigid rear and assuring good alignment under all conditions. However, because of the greater unsprung weight of the torque tube and radius rods there may be a "little hopping around of the rear end when cornering fast or on washboard roads" 抄文引用元・出典: フリー百科事典『 ウィキペディア（Wikipedia）』 ■ウィキペディアで「Torque tube」の詳細全文を読む スポンサード リンク
|